Working Wednesday, 10/4/2017
Working Wednesday tonight at the club station, 5923 Rowan. We should have someone there by around 1800. Lot’s of work to be done. A few things we’ll be working on:...
Operator and Sponsor of the Radio Science and Operations Center (RSOC)
Anything and everything to do with high speed mesh networking
Working Wednesday tonight at the club station, 5923 Rowan. We should have someone there by around 1800. Lot’s of work to be done. A few things we’ll be working on:...
As part of our Hillside South location upgrade and to replace the old KL7AA APRS Digipeater/I-Gate formerly operated from the club station, we purchased a Microsat WX3in1 APRS Advanced Digipeater/I-Gate...
On Monday, September 25, I traveled out to Fire Station 61 in Wasilla to test connectivity and throughput with a Ubiquiti RocketDish/Rocket M3 radio to our Site Summit node. A...
We’ve noticed some intermittent connectivity between the EARS MESH node and the Site Summit MESH node since installation last week. We made a second trip up to Site Summit a...
I just assembled a RocketDish 3G26 for testing MESH connectivity from various locations to the new Site Summit node. Check out the time lapse video of the assembly. Please forgive...
KL7MD and KL5T trekked up to Site Summit again late yesterday afternoon to make some antenna alignment adjustments for the MESH node. We weren’t satisfied with the signal levels between...
WORKING WEDNESDAY – 2017.09.20 @ 1800 – 2100 01). SNIPER’S NET CHECK-IN: 1800 to 1820 02). TEST HF WINLINK CONNECTIVITY TO FAIRBANKS / ANMC 03). SENIOR CENTER – FIND ORIGINAL...
In the previous blog post we mentioned that we installed a MESH node at the Site Summit repeater site. To be more specific, this included a Ubiquiti Rocket M3 Radio...
A big work crew attacked the Site Summit 147.30/90 repeater site yesterday. Mike, KL7MD, facilitated site access and Dave, AL7LO led the effort to rewire the entire repeater and packet...
Working Wednesday was productive tonight (9/6/2017) as a gang of us engineered an installation plan, built a Cat5e cable, set the down-angle tilt, upgraded AREDN firmware in the Ubiquiti M3...
You must be logged in to post a comment.