FCC Site – We don’t need no stinking noise floor!
I finally caught up with Pat Wilke, KL7JA a few days ago. Pat hung out with me in the tent for a good portion of the night during Field Day...
Operator and Sponsor of the Radio Science and Operations Center (RSOC)
I finally caught up with Pat Wilke, KL7JA a few days ago. Pat hung out with me in the tent for a good portion of the night during Field Day...
KL7MD and KL5T trekked up to Site Summit again late yesterday afternoon to make some antenna alignment adjustments for the MESH node. We weren’t satisfied with the signal levels between...
WORKING WEDNESDAY – 2017.09.20 @ 1800 – 2100 01). SNIPER’S NET CHECK-IN: 1800 to 1820 02). TEST HF WINLINK CONNECTIVITY TO FAIRBANKS / ANMC 03). SENIOR CENTER – FIND ORIGINAL...
Kent (KL5T) and Sid (KL7SID) did a bit more work at the Anchorage Senior Center on Friday, 9/15. We installed PL259 connectors on each end of the LMR-400 coaxial cable...
In the previous blog post we mentioned that we installed a MESH node at the Site Summit repeater site. To be more specific, this included a Ubiquiti Rocket M3 Radio...
A big work crew attacked the Site Summit 147.30/90 repeater site yesterday. Mike, KL7MD, facilitated site access and Dave, AL7LO led the effort to rewire the entire repeater and packet...
Dave Heimke (AL7LO), member of the club’s Building Committee, reported at the club meeting last Friday that there have been recent developments in our efforts to secure occupancy for our...
Working Wednesday was productive tonight (9/6/2017) as a gang of us engineered an installation plan, built a Cat5e cable, set the down-angle tilt, upgraded AREDN firmware in the Ubiquiti M3...
KL5T should be on site by between 1845 and 1900 to open the club for Working Wednesday. Not sure if anyone will be there earlier. KL7TS and KL7MM are out...
Dave Heimke (AL7LO) reports that he and Mike O’Keefe (KL7MD) visited Site Summit today to prep for major DC supply system upgrades and other repeater-related matters. While there, a preliminary...
You must be logged in to post a comment.